 |
|
|
CLIPBOARDS: 3RC clipboards are made from limited-production PCBs that were manufactured in various sizes, from one inch up to about 24x40 inches, depending on their ultimate application. PCBs are made from ‘innerlayers’ – paper-thin, but
very strong and flexible sheets of fiberglass-epoxy upon which are created intricate circuits made of copper. These innerlayers are stacked and heated under pressure to produce a 3-dimensional composite. The layers are connected by “through-holes”, some thinner than a human hair. Electrical conductivity between the layers is accomplished by immersing the entire board in liquid solder inside a vacuum chamber. The solder coats the insides of the holes and allows electrons to flow between the layers. A PCB is therefore a complex 3-dimensional circuit. Modern PCBs can have as many as 30 layers. Electronic components such as resistors, transistors, capacitors, etc. are attached by soldering them to the surface of a board to produce a finished product, such as the motherboard of a computer.
|
|
THREE RING CIRCUITS
Green Office Products Made From Recycled Circuit Boards
3rc Clipboards
Our clipboards are environmentally responsible office products. All sharp corners are hand-smoothed and the clips are made of ultra-strong stainless steel. Limited production of the original prototypes means that only a handful of each board style is available; however, there is a wide variety of shapes, sizes and colors to choose from. The largest boards are big enough to handle legal-size pads; the smallest ones are intended for small paper and post-it pads, and are magnetized (with an extra-large sheet of magnetic material) to allow them to stick to refrigerators, file cabinets, wallboards, etc.The mid-size clipboards are just right for papers in sizes from about 6x4 to 8x6 inches.
When ordering, please let us know if you have a preference for color or a specific paper size that can be accommodated.
|
|
